Table of Contents
Advertisement
AIRBAG SYSTEM
8. Airbag Control Module
A: REMOVAL
CAUTION:
• Do not disassemble the airbag control mod-
ule.
• If the airbag control module is deformed or if
the fault occurs by water, replace the airbag
control module with a new one.
• Do not drop the airbag control module.
• After removal, keep the airbag control mod-
ule on a dry, clean surface away from moisture,
heat and dust.
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the console front panel and console
side garnish. <Ref. to EI-54, REMOVAL, Center
Console.>
4) Remove the screws and pull out the audio unit
assembly and disconnect the connector for remov-
al.
5) Disconnect the connector from airbag control
module.
6) Remove the bolts and remove airbag control
module.
Airbag Control Module
B: INSTALLATION
CAUTION:
• Do not reuse the bolt and nut
• Always use new bolts and nuts for them.
• Be sure to cover with connector water protec-
tion cover.
Install in the reverse order of removal.
Tightening torque:
25 N
C: INSPECTION
Perform the inspection of the following items, and
replace the damaged parts with new ones.
• Control module, connector and mounting bracket
are damaged.
• Airbag is deployed.
• Side airbag is deployed.
• Curtain airbag is deployed.
EI-00794
AB-00759
AB-22
⋅
m (2.5 kgf-m, 18.1 ft-lb)
Advertisement
Chapters
Table of Contents
