Subaru Legacy 2005 Service Manual page 3373

11) Using a press, press-fit until the groove of ST
are aligned to the end surface of holder.
(2)
(1) Groove
(2) Holder
12) Secure the gearbox in a vise using ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
(1) Clamp
13) Tighten the holder.
Tightening torque:
⋅
70 N m (7.1 kgf-m, 51.6 ft-lb)
(1) Holder
Steering Gearbox [LHD Model]
ST
(1)
PS-00522
(1)
ST1
ST2
PS-00492
(1)
PS-00512
POWER ASSISTED SYSTEM (POWER STEERING)
14) Using the ST, caulk so that the diameter of
punch hole is 2 — 2.5 mm (0.08 — 0.10 in) and is
aligned to the position of 2 mm from gearbox cylin-
der end surface.
ST 34099FA060 PUNCH HOLDER
(1) 2 mm (0.08 in)
(2) Diameter: 2
(3) End of cylinder
(4) Holder
15) Put a vinyl tape around the spline portion and
apply genuine grease to the dust cover and install
to valve assembly.
CAUTION:
Be sure to install the dust cover to groove of
shaft.
(1) Dust cover
(2) Groove
16) Apply genuine grease to the pinion gear and
bearing of valve assembly.
PS-35
(1)
(2)
(4)
(3)
PS-00523
— —
2.5 mm (0.08 0.10 in)
(1)
(2)
PS-00534
PS-00165