Subaru Legacy 2005 Service Manual page 3404

POWER ASSISTED SYSTEM (POWER STEERING)
7. Pipe Assembly [LHD Model]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the front
crossmember support plate and jack-up plate.
• Small type
(1)
(1) Front crossmember support plate
(2) Jack-up plate
• Small type (6MT model)
(2)
(1)
(1) Front crossmember support plate
(2) Jack-up plate
3) Remove one pipe joint at the center of gearbox,
and connect the vinyl hose to the pipe and the joint.
Discharge the fluid by turning steering wheel fully
clockwise and counterclockwise. Discharge the flu-
id similarly from other pipes.
(1) Pipe A
(2) Pipe B
Pipe Assembly [LHD Model]
(1)
(2)
FS-00105
(1)
FS-00186
(1)
(2)
PS-00553
4) Remove the clamp E from the return hose and
pressure hose.
(1) Return hose
(2) Pressure hose
(3) Clamp E
5) Disconnect the pipe D from the return hose and
pipe C from pressure hose.
(1) Pipe C
(2) Pipe D
(3) Pressure hose
(4) Return hose
6) Remove the air intake duct. <Ref. to IN(H4SO
2.0)-8, REMOVAL, Air Intake Duct.>
PS-66
(3)
(2)
(1)
PS-00537
(4)
(3)
(2)
PS-00538
(1)