Subaru Legacy 2005 Service Manual page 3393

22) While fixing the 2-surface width, pull out the oil
seal by rotating nut.
CAUTION:
Take care not to scratch the gearbox inner sur-
face.
(1) 2-surface width
(2) Nut
D: ASSEMBLY
1) Apply a coat of grease to the inside and outside
of new oil seal.
Steering grease:
VALIANT GREASE M2 (Part No. 003608001)
2) Verify the direction of oil seal and installation po-
sition. Using the ST and press, press-fit the oil seal
to gearbox.
ST 34199AE130 GEARBOX OIL SEAL IN-
STALLER
(1) Oil seal
Steering Gearbox [RHD Model]
PS-00072
PS-00073
PS-55
POWER ASSISTED SYSTEM (POWER STEERING)
3) Attach the steering body to ST as shown in the
figure. Apply a coat of grease to needle bearing.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
CAUTION:
Ensure the needle bearing is free from defects.
If it is faulty, replace the steering body with a
new one.
(1) Clamp
4) Using the ST-B and ST-C, install the oil seal to
ST-A.
ST 34199FE040 INSTALLER A, B, C (Turbo
and 3.0 R model)
ST 927490000 INSTALLER A, B, C (Except
for turbo and 3.0 R model)
NOTE:
Face the oil seal in the direction as shown in the fig-
ure.
ST B
ST C
(A) Oil seal
(1)
ST1
ST2
PS-00492
ST A
(A)
PS-00075