Subaru Legacy 2005 Service Manual page 3559

11.Roll Connector
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the driver's airbag module. <Ref. to AB-
16, REMOVAL, Driver's Airbag Module.>
4) Remove the steering wheel. <Ref. to PS-21, RE-
MOVAL, Steering Wheel.>
5) Remove the steering column cover.
6) Remove the screws, and then remove the roll
connector.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Before installing steering wheel, adjust the direc-
tion of roll connector to steering. <Ref. to AB-25,
ADJUSTMENT, Roll Connector.>
C: INSPECTION
Perform the inspection of the following items, and
replace the damaged parts with new ones.
• Combination switch and roll connector are
cracked or deformed.
D: ADJUSTMENT
1) Check that front wheels are positioned in straight
ahead direction.
2) Turn the roll connector pin (A) clockwise until it
stops.
3) Turn the roll connector pins (A) approx. 3.25
turns until "▲" marks are aligned.
Roll Connector
AB-00760
(A)
AB-00594
AB-25
AIRBAG SYSTEM