Subaru Legacy 2005 Service Manual page 3388

POWER ASSISTED SYSTEM (POWER STEERING)
23) After adjusting toe-in and steering angle, tight-
en the lock nut on tie-rod end.
Tightening torque:
⋅
85 N m (8.7 kgf-m, 62.7 ft-lb)
NOTE:
When adjusting toe-in, hold the boot as shown to
prevent it from being rotated or twisted. If twisted,
straighten it.
C: DISASSEMBLY
1) Disconnect the pipes A and B from steering body
and control valve housing.
(2)
(1) Pipe A
(2) Pipe B
Steering Gearbox [RHD Model]
PS-00051
(1)
PS-00496
2) Secure the gearbox removed from vehicle in a
vise using ST.
ST1 926200000
ST2 34199AG000 BOSS D
CAUTION:
Secure the gearbox assembly in a vise using
the ST as shown. Do not secure the gearbox
without this ST.
(1) Clamp
3) Remove the tie-rod end and lock nut from gear-
box.
4) Remove the clip from outside boot using pliers,
and then move the boot to tie-rod end side.
(1) Clip
PS-50
STAND
(1)
ST1
ST2
PS-00492
PS-00053