Subaru Legacy 2005 Service Manual page 3562

Hide thumbs Also See for Legacy 2005:

Table of Contents

Airbag Module Disposal (Deployment Processing on Vehicle)

AIRBAG SYSTEM

8) Extend fully the wiring of deployment tool, and

make sure that the vehicle is empty. Close all the

windows, sunroof and rear gate completely.

9) Move the battery at least 5 m (16 ft) from vehicle,

and secure the nearby area. Connect the deploy-

ment tool alligator clip to the battery negative (−)

10) Connect the other cable of deployment tool to

the battery positive (+) terminal, and deploy the air-

• After deployment, the airbag module is ex-

tremely hot, leave it unattended for 40 minutes,

and discard it.

• Do not let water get into the deployed airbag

11) Remove the airbag module. <Ref. to AB-16,

Driver's Airbag Module.>

12) Wrap the deployed airbag module in sealed vi-

nyl bag, and discard it.

2. PASSENGER'S AIRBAG MODULE

1) Turn the ignition switch to OFF.

2) Disconnect the ground cable from battery and

wait for at least 20 seconds before starting work.

3) Remove the instrument panel side cover of pas-

senger's side and disconnect the airbag connector.

4) Short the terminal to the alligator clip furnished

as deployment tool (A).

5) Connect the deployment tool (A) and deploy-

ment adapter E (B).

The deployment tool should be kept shorted

terminal until just before deployment of airbag

6) Connect the deployment adapter E to airbag

connector (AB10).

(A) Deployment tool:

(Tool number 98299PA030)

(B) Deployment adapter E:

(Tool number 98299SA030)

Chapters

Table of Contents