Subaru Legacy 2005 Service Manual page 3321

3) Position the disc in straight-forward direction and
route the brake hose through the hole in bracket on
wheel apron side.
CAUTION:
Be sure the brake hose is not twisted.
4) Temporarily tighten the flare nut to connect the
brake pipe and hose.
5) Fix the brake hose with clamp at wheel apron
bracket.
6) Tighten the flare nut to specified torque.
Tightening torque (Brake pipe flare nut):
⋅
15 N m (1.5 kgf-m, 10.8 ft-lb)
7) Bleed air from brake system.
2. Rear brake hose
1) Pass the brake hose through the hole of bracket,
and lightly tighten the flare nut to connect brake
pipe.
2) Insert the clamp upward to fix brake hose.
(2)
(3)
(1) Brake pipe
(2) Brake hose
(3) Brake hose clamp
(2)
(1)
(1) Brake pipe
(2) Brake hose clamp
Brake Hose
3) Install the brake hose to rear brake caliper using
a new gasket.
Tightening torque (Union bolt):
18 N
4) Tighten the flare nut to specified torque.
Tightening torque (Brake pipe flare nut):
15 N
5) Bleed air from the brake system.
C: INSPECTION
(1)
Ensure there are no cracks, breakage or damage
on hoses. Check joints for fluid leakage. If any
cracks, breakage, damage or fluid leakage is
found, repair or replace the hose.
BR-00350
BR-00349
BR-41
⋅
m (1.8 kgf-m, 13.0 ft-lb)
(1)
(1) Brake hose
⋅
m (1.5 kgf-m, 10.8 ft-lb)
BRAKE
BR-00348