Subaru Legacy 2005 Service Manual page 3368

POWER ASSISTED SYSTEM (POWER STEERING)
7) Tighten the adjusting screw until it no longer
tightens.
(1) Adjusting screw
8) While securing the rack with a wrench (22 mm),
remove the tie-rod using a wrench (32 mm (1.26
in)) or adjustable wrench.
9) Loosen the adjusting screw and remove the
spring and sleeve.
10) Remove the two bolts securing valve assem-
bly.
Steering Gearbox [LHD Model]
(1)
PS-00495
PS-00511
PS-00116
PS-30
11) Carefully draw out the input shaft and remove
the valve assembly.
12) Using a drill, release the caulking of holder.
CAUTION:
Make a hole of 2 mm (0.08 in) depth using a drill
with 3 mm (0.12 in) diameter.
13) Remove the holder using a 36 mm spanner or
adjustable wrench.
(1) Holder
14) Remove the rack bushing and rack stopper
from rack assembly.
15) Remove the oil seal from rack.
PS-00117
PS-00516
(1)
PS-00512