Subaru Legacy 2005 Service Manual page 3311

Hide thumbs Also See for Legacy 2005:

Table of Contents

4) With pushing-in the primary piston, remove the

C-ring using pliers.

5) With pushing-in the primary piston, remove the

straight pin from the port on installation part of res-

ervoir tank using magnet pick-up tool.

(1) Straight pin

6) Extract the primary piston assembly and sec-

ondary piston assembly straight out, while taking

care not to scratch the inner surface of cylinder.

7) Clean the inside of master cylinder with brake

fluid. Check the inside of cylinder for damage, de-

form, wear and rust. Replace the master cylinder

as assembly if faulty.

8) Apply brake fluid to the inner surface of master

cylinder and piston assembly.

9) Ensure that the inner surface of master cylinder

and piston assembly are free of dirt before assem-

bling. Install the primary piston assembly and sec-

ondary piston assembly to master cylinder, while

taking care not to scratch the master cylinder inner

10) With pushing-in the primary piston, install the

cylinder pin.

Master Cylinder

11) With pushing-in the primary piston, install the

C-ring to groove using pliers.

Ensure the secure installation to the groove.

12) Install the seal to reservoir tank.

13) Install the reservoir tank to master cylinder, and

secure with pin.

14) Replace the O-ring for the master cylinder with

(1) Primary piston

(3) Do not install the O-ring on this groove.

Chapters

Table of Contents