Table of Contents
Advertisement
9. Side Airbag Sensor
A: REMOVAL
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the center pillar lower trim. <Ref. to EI-
60, REMOVAL, Lower Inner Trim.>
4) Remove the center pillar inner protector lower.
5) Remove the front outer seat belt retractor. <Ref.
to SB-14, OUTER SEAT BELT ASSEMBLY, RE-
MOVAL, Front Seat Belt.>
6) Remove the nut and disconnect the airbag con-
nector to remove side airbag sensor.
B: INSTALLATION
CAUTION:
• Do not reuse the bolt and nut
• Always use new bolts and nuts for them.
Install in the reverse order of removal.
Tightening torque:
⋅
7.4 N
m (0.75 kgf-m, 5.5 ft-lb)
C: INSPECTION
Perform the inspection of the following items, and
replace the damaged parts with new ones.
• Mounting bracket or connector of side airbag
sensor is damaged.
• Side airbag is deployed.
Side Airbag Sensor
SB-00144
AB-00634
AB-23
AIRBAG SYSTEM
Advertisement
Chapters
Table of Contents
