Subaru Legacy 2005 Service Manual page 3561

Airbag Module Disposal (Deployment Processing on Vehicle)
13.Airbag Module Disposal (De-
ployment Processing on Ve-
hicle)
A: PROCEDURE
CAUTION:
• Do not discard an undeployed airbag mod-
ules because it may cause a serious personal
injury when accidentally deployed.
• As a rule, airbag modules should be de-
ployed in the vehicle. Do not remove the airbag
modules unless necessary.
• Deployment of airbag modules should be
performed on a flat place in safety area. Avoid
deploying outdoors when rainy or windy weath-
er.
• Deploying an airbag module causes a high
explosive noise, be sure to warn people in the
area, and do not allow anyone within 5 m (16 ft)
radius of the disposal site.
• Some smoke will be emitted after deployment
of the airbag module. Therefore, it must be de-
ployed in a well-ventilated place with no smoke
detector nearby.
• Wear protective gloves, safety goggles and
earplugs during this operation. Wash your
hands afterwards.
• After deployment, the airbag module is ex-
tremely hot, leave it unattended for 40 minutes,
and discard it.
• Do not let water into the deployed airbag
module.
• Wrap the deployed airbag module in a sealed
vinyl bag, and discard it.
• If circumstances do not permit the airbag
module deployment, contact the SUBARU deal-
er.
1. DRIVER'S AIRBAG MODULE
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the instrument panel lower cover upper.
<Ref. to EI-50, REMOVAL, Instrument Panel Low-
er Cover.>
4) Disconnect the airbag connector.
5) Short the terminal to the alligator clip furnished
as deployment tool (A).
6) Connect the deployment tool and deployment
adapter E (B).
CAUTION:
The deployment tool should be kept shorted
terminal until just before deployment of airbag
module.
(A) Deployment tool:
(Tool number 98299PA030)
(B) Deployment adapter E:
(Tool number 98299SA030)
7) Connect the deployment adapter E (1) to airbag
connector (AB7).
(1)
(1) Deployment adapter E:
(Tool number 98299SA030)
AB-27
AIRBAG SYSTEM
AB-00761
SB-00016
(AB7)
AB-00762