Subaru Legacy 2005 Service Manual page 3564

Hide thumbs Also See for Legacy 2005:

Table of Contents

Airbag Module Disposal (Deployment Processing on Vehicle)

AIRBAG SYSTEM

7) Connect the deployment adapter A (1) to the

side airbag module connector (yellow).

• Do not place any object on front seat.

• Deploy the side airbag one by one and dis-

8) Extend fully the wiring of deployment tool, and

make sure that the vehicle is empty. Close all the

windows, sunroof and rear gate completely.

9) Move the battery at least 5 m (16 ft) from vehicle,

and secure the nearby area. Connect the deploy-

ment tool alligator clip to the battery negative (−)

10) Connect the other cable of deployment tool to

the battery positive (+) terminal, and deploy the air-

• After deployment, the airbag module is ex-

tremely hot, leave it unattended for 40 minutes,

and discard it.

• Do not let water get into the deployed airbag

11) Remove the side airbag module. <Ref. to AB-

18, REMOVAL, Side Airbag Module.>

12) Wrap the deployed airbag module in sealed vi-

nyl bag, and discard it.

4. CURTAIN AIRBAG MODULE

1) Turn the ignition switch to OFF.

2) Disconnect the ground cable from battery and

wait for at least 20 seconds before starting work.

3) Remove the rear quarter trim. <Ref. to EI-63,

REMOVAL, Rear Quarter Trim.>

4) Disconnect the curtain airbag harness.

• Sedan model

• Wagon model

5) Short the terminal to the alligator clip furnished

as deployment tool (A).

Chapters

Table of Contents