Subaru Legacy 2005 Service Manual page 3398

POWER ASSISTED SYSTEM (POWER STEERING)
27) Caulk the boot so that the clearance of boot
band caulking portion becomes 2 mm (0.08 in) or
less.
NOTE:
Use a new boot band.
(A)
(A) Boot band
(B) 2 mm (0.08 in) or less
28) Fix the boot end with clip (small).
(1) Clip
29) After installing, check that the boot end is posi-
tioned into groove on tie-rod.
30) If the tie-rod end has been removed, screw in
lock nut and tie-rod end to the screwed portion of
tie-rod, and tighten the lock nut temporarily in a po-
sition as shown in the figure.
Steering Gearbox [RHD Model]
(B)
PS-00499
PS-00053
Installed tie-rod length L:
31 mm (1.22 in)
31) Inspect the gearbox as follows:
"A" Holding tie-rod end, repeat lock to lock two or
three times as quickly as possible.
"B" Holding tie-rod end, turn it slowly at a radius one
or two times as large as possible.
After all, make sure that the boot is installed in the
specified position without deflation.
32) Remove the gearbox from ST.
ST1 926200000
ST2 34199AG000 BOSS D
33) Install the pipe A and B to steering body and
control valve housing.
Tightening torque:
⋅
T1: 20 N m (2.0 kgf-m, 14.5 ft-lb)
⋅
T2: 24 N m (2.4 kgf-m, 17.4 ft-lb)
T1
(2)
(1) Pipe A
(2) Pipe B
PS-60
L
PS-00097
A
B
PS-00098
STAND
T1
T2
T2
(1)
PS-00500