Table of Contents
Advertisement
BRAKE
5) Install the pad on support.
NOTE:
Install the pad indicator in proper direction.
(1)
(2)
(6)
(3)
(6)
(5)
(4)
(1) LH − IN
(2) LH − OUT
(3) RH − IN
(4) RH − OUT
(5) Pad indicator
(6) Pad return spring
CAUTION:
• Be sure to install so that the direction of pad
return spring faces to the input side of brake ro-
tor rotation direction as shown in the figure.
• Correctly install the pad return spring to sup-
porting surface of pad clip as shown in the fig-
ure.
Front Disc Brake Assembly
• When the pad return spring is deformed or
damaged, replace the brake pad with new one.
(6)
(5)
6) Install the caliper body on support.
7) Connect the brake hose using new brake hose
gaskets.
Tightening torque:
8) Bleed air from the brake system.
(6)
C: DISASSEMBLY
BR-00342
1. 15-INCH TYPE
1) Clean mud and foreign particles from the caliper
body assembly and the support.
CAUTION:
Be careful not to allow foreign particles to enter
the brake hose connector.
2) Place a wooden block in caliper body as shown
in the figure to prevent the piston from jumping out
and avoid being damaged.
3) Gradually supply compressed air via installation
hole of brake hose to force the piston out.
BR-22
(3)
(1) Pad return spring
(2) Supporting surface of pad clip
(3) Brake rotor rotation direction
⋅
18 N
m (1.8 kgf-m, 13.0 ft-lb)
(1) Place a 30 mm (1.18 in) wide wood block here.
(1)
(2)
BR-00483
(1)
BR-00026
Advertisement
Chapters
Table of Contents
