Subaru Legacy 2005 Service Manual page 3390

POWER ASSISTED SYSTEM (POWER STEERING)
11) Align the ST pin with the plug hole to install. Ro-
tate the ST counterclockwise to remove the plug.
ST 34199AE090 PLUG WRENCH
(1) Plug
12) Remove the valve assembly paying attention
not to scratch seal ring or valve housing inner sur-
face.
(1) Valve ASSY
(2) Seal ring
Steering Gearbox [RHD Model]
PS-00061
PS-00062
PS-52
13) Remove the holder using a 36 mm spanner or
adjustable wrench.
14) Install the ST on valve side of rack and press
outer side oil seal out taking care not to contact
rack with steering body inner surface.
ST 34199FE000 INSTALLER & REMOVER
(Turbo and 3.0 R model)
ST 34099FA030 INSTALLER & REMOVER
(Except for turbo and 3.0 R
model)
NOTE:
Block the pipe connection of steering body to pre-
vent fluid from flowing out.
(1) Rack piston
(2) Outer side oil seal
PS-00498
PS-00064