Table of Contents
Advertisement
POWER ASSISTED SYSTEM (POWER STEERING)
• Turbo model
(1)
(2)
(1) Suction hose
(2) Pressure hose
4) Connect the connector to power steering pump
switch.
5) Install the V-belts to oil pump.
6) Check the tension of V-belt.
<Ref. to ME(H4SO 2.0)-38, INSPECTION, V-belt.>
7) Tighten the belt tension bolt.
Tightening torque:
⋅
25 N
m (2.5 kgf-m, 18.4 ft-lb)
8) Install the pulley belt cover.
9) Install the air intake duct.
<Ref. to IN(H4DOTC)-9, INSTALLATION, Air In-
take Duct.> <Ref. to IN(H4SO 2.0)-8, INSTALLA-
TION, Air Intake Duct.>
10) Connect the ground cable to battery.
11) Feed the specified power steering fluid. <Ref.
to PS-91, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid
otherwise vane pump might be seized up.
Oil Pump
2. H6 MODEL
1) Install the oil pump to bracket.
(1) Place the oil pump bracket in a vise. Tighten
the bushing using a 12.7 mm (1/2") type 14- and
21-mm box wrench until it is in contact with oil
pump mounting surface.
CAUTION:
When securing the oil pump bracket in a vise,
hold the oil pump bracket with the least possi-
ble force between two wood pieces.
PS-00459
(2) Tighten the bolt which installs oil pump to
bracket.
Tightening torque:
15.7 N
PS-84
(1) Bushing
(2) Nut
(3) 21 mm
(4) 14 mm
(5) Bolt
⋅
m (1.6 kgf-m, 11.6 ft-lb)
PS-00135
PS-00229
Advertisement
Chapters
Table of Contents
