Subaru Legacy 2005 Service Manual page 3616

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

AIRBAG SYSTEM (DIAGNOSTICS)
Step
2
CHECK ROLL CONNECTOR.
1) Turn the ignition switch OFF, disconnect the
battery ground cable, and wait more than 20
seconds.
2) Disconnect the test harness N from con-
nector (AB38).
3) Disconnect the test harness Q from con-
nector (AB37).
4) Remove the instrument panel lower cover
and disconnect the connector (AB7) from
(AB2).
5) Connect the connector (1P) in the test har-
ness P to connector (AB2).
6) Connect the airbag resistor to connectors
(2P) and (3P) in the test harness P.
7) Connect the battery ground cable and turn
the ignition switch to ON.
3
CHECK AIRBAG MAIN HARNESS (DRIV-
ER'S AIRBAG HARNESS).
1) Turn the ignition switch OFF, disconnect the
battery ground cable, and wait more than 20
seconds.
2) Disconnect the airbag resistor from con-
nectors (2P) and (3P) in the test harness P.
3) Remove the instrument panel side cover on
passenger's side and disconnect the connec-
tors (AB10) and (AB9).
4) Disconnect the connector (AB6) from air-
bag control module, and connect the connector
(1U) in the test harness U.
5) Measure the resistance between connector
(2U) in the test harness U and connectors (2P)
and (3P) in the test harness P.
Connector & terminal
(2U) No. 2 — (2P) No. 1:
(2U) No. 4 — (2P) No. 2:
(2U) No. 8 — (3P) No. 3:
(2U) No. 12 — (3P) No. 4:
4
CHECK AIRBAG MAIN HARNESS (DRIV-
ER'S AIRBAG HARNESS).
Measure the resistance between connector
(2U) terminals in the test harness U.
Connector & terminal
(2U) No. 2 — (2U) No. 4:
(2U) No. 4 — Chassis ground:
(2U) No. 2 — Chassis ground:
(2U) No. 8 — (2U) No. 12:
(2U) No. 8 — Chassis ground:
(2U) No. 12 — Chassis ground:
Diagnostic Chart with Trouble Code
Does the airbag warning light
illuminate for 6 seconds and go
off?
Is the resistance less than 10
Ω?
Is the resistance more than 1
MΩ?
AB(diag)-44
Check
Replace the roll
connector. <Ref. to
AB-25, Roll Con-
nector.>
Go to step 4.
Replace the airbag
control module.
<Ref. to AB-22,
Airbag Control
Module.>
Yes
No
Go to step 3.
Replace the airbag
main harness with
body harness.
Replace the airbag
main harness with
body harness.

Advertisement

Table of Contents
loading

Table of Contents