Subaru Legacy 2005 Service Manual page 3415

• Turbo model
(1)
(2)
(1) Suction hose
(2) Pressure hose
5) Temporarily connect the return hose and pres-
sure hose to gearbox. Place the clamp E in the po-
sition shown in the figure, and tighten the bolt
temporarily.
(4)
(1)
(3)
(1) Return hose
(2) Pressure hose
(3) Approx. 27 mm (1.06 in)
(4) Clamp E
Pipe Assembly [RHD Model]
PS-00459
(2)
PS-00467
POWER ASSISTED SYSTEM (POWER STEERING)
NOTE:
Ensure that the letter "8" on each clamp are diago-
nally opposite each other as shown in the figure.
(2)
(1) Clamp E
(2) Pipe C
(3) Return hose
6) Tighten the clamp E.
Tightening torque:
⋅
7.4 N m (0.75 kgf-m, 5.4 ft-lb)
7) Tighten the joint nut.
Tightening torque:
⋅
15 N m (1.5 kgf-m, 10.8 ft-lb)
8) Connect the pipe A and B to the four pipe joints
of gearbox.
Tightening torque:
Housing side
⋅
20 N m (2.0 kgf-m, 14.5 ft-lb)
Cylinder side
⋅
24 N m (2.4 kgf-m, 17.4 ft-lb)
(1) Pipe A
(2) Pipe B
9) Install the front crossmember support plate and
jack-up plate.
10) Lower the vehicle.
PS-77
(1)
(3)
PS-00540
(1)
(2)
PS-00446