Table of Contents
Advertisement
• If any damage, opening or rust is found on the
airbag system wire harness, do not attempt to re-
pair using soldering equipment. Replace the faulty
harness with a new genuine part.
• Install the wire harness securely with the speci-
fied clips to avoid interference or tangled up with
other parts.
• Do not allow water or oil to come in contact with
the connector terminals. Also do not touch the con-
nector terminals.
• Either of the airbag modules for driver's side,
passenger's, side and curtain or pretensioner must
not be disassembled.
General Description
• The airbag module cannot be used again if de-
ployed once.
• After removal, keep the airbag module with the
AB-00124
pad facing upward on a dry, clean and flat surface
away from heat, light sources, moisture and dust.
• Do not check continuity of the airbag modules for
AB-00125
driver's side, passenger's side and curtain, or pre-
tensioner.
AB-00126
AB(diag)-5
AIRBAG SYSTEM (DIAGNOSTICS)
AB-00127
AB-00056
AB-00006
Advertisement
Chapters
Table of Contents
