Subaru Legacy 2005 Service Manual page 3379

19) Insert the valve assembly into place while fac-
ing the rack teeth toward pinion.
20) Tighten the bolts alternately to secure the valve
assembly.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
CAUTION:
Be sure to alternately tighten the bolts.
21) Apply liquid gasket around the center of adjust-
ing screw threads.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
22) Apply a coat of grease to the sliding surface of
sleeve and seating surface of spring, and then in-
sert the sleeve into steering body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw and install on
steering body.
(1)
(1) Sleeve
(2) Spring
(3) Adjusting screw
23) Tighten the adjusting screw to the specified
torque, then loosen it.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
24) After tightening the adjusting screw with the
specified tightening torque, loosen it by 20°.
Tightening torque:
⋅
3.9 N m (0.4 kgf-m, 2.9 ft-lb)
Steering Gearbox [LHD Model]
PS-00143
(3)
(2)
PS-00167
PS-41
POWER ASSISTED SYSTEM (POWER STEERING)
25) Verify that play is within the specification. <Ref.
to PS-43, SERVICE LIMIT, INSPECTION, Steering
Gearbox [LHD Model].>
26) Install the lock nut. While holding the adjusting
screw with a wrench, tighten the lock nut using ST.
ST 926230000 SPANNER
Tightening torque (Lock nut):
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening lock nut.
27) Remove the gearbox from ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
28) Install the four pipes on gearbox.
(1) Connect the pipes A and B to gearbox.
Tightening torque:
⋅
13 N m (1.3 kgf-m, 9.6 ft-lb)
(2) Connect the pipes C and D to gearbox.
Tightening torque:
⋅
Pipe C: 15 N m (1.5 kgf-m, 10.8 ft-lb)
⋅
Pipe D: 25 N m (2.5 kgf-m, 18.4 ft-lb)
(2)
(1)
(1) Pipe C
(2) Pipe D
PS-00525