Subaru Legacy 2005 Service Manual page 3545

2. Airbag Connector
A: PROCEDURE
1. POWER SUPPLY
1) How to disconnect:
(1) Move the slide lock (A) in the direction of ar-
row.
(2) While holding the slide lock (A) in moved po-
sition, separate the connector.
CAUTION:
When pulling the slide lock or disconnecting
the connector, be sure to hold the connector,
not the harness.
2) How to connect:
Holding the connector (A), and push it in securely
until a connecting sound is heard.
CAUTION:
Be sure to insert the connector until it is locked.
Pull it gently to make sure that it is locked se-
curely.
Airbag Connector
(A)
AB-00721
AB-00016
2. DRIVER'S AIRBAG MODULE, PRETEN-
SIONER AND LAP SEAT BELT PRETEN-
SIONER
1) How to disconnect:
(1) Using a flat tip screwdriver, pry the push
lock upward to unlock.
(2) Pull the connector to disconnect from driv-
er's side airbag module assembly or retractor
assembly.
2) How to connect:
Connect the connector in the reverse order of dis-
connecting. At this time, be sure to insert the push
lock until a connecting sound is heard.
CAUTION:
• Be sure to insert the connector in until it is
locked. Pull it gently to make sure that it is
locked securely.
• Be sure to push the push lock in securely.
NOTE:
The connector can not be connected when the
push lock is in lock position. To connect the con-
nector, set the push lock to unlock position.
AB-11
AIRBAG SYSTEM
AB-00478
AB-00479
AB-00480