Subaru Legacy 2005 Service Manual page 3377

5) Press the oil seal into position using press.
ST 34199AG090 INSTALLER & REMOVER
6) Install the bearing to ST and position it to hous-
ing. Using the ST and a press, install the special
bearing in valve housing.
ST 34199AG090 INSTALLER & REMOVER
(1) Special bearing
(2) Oil seal
7) Apply vinyl tape to the groove of pinion.
Steering Gearbox [LHD Model]
ST
PS-00526
ST
(1)
(2)
PS-00527
PS-39
POWER ASSISTED SYSTEM (POWER STEERING)
8) Install the back-up ring and oil seal to pinion, and
then remove the vinyl tape.
(1)
(1) Oil seal
(2) Vinyl tape
(3) Back-up ring
9) Install the ST to pinion, and install the seal ring.
ST 34199AG020 GUIDE
ST
(1) Seal ring
10) Remove the ST GUIDE, and form the seal ring
properly using ST FORMER.
ST 34199AG070 FORMER
ST
(1) Seal ring
11) Put vinyl tape around pinion shaft spline to pro-
tect oil seal from damage.
(3)
(2)
PS-00528
(1)
PS-00529
(1)
PS-00530