Subaru Legacy 2005 Service Manual page 3376

POWER ASSISTED SYSTEM (POWER STEERING)
33) After installing, check the boot end is installed
to the groove of tie-rod.
34) If the tie-rod end has been removed, screw in
the lock nut and tie-rod end to the screwed portion
of tie-rod, and tighten the lock nut temporarily in a
position as shown in the figure.
Installed tie-rod length L:
31 mm (1.22 in)
35) Inspect the gearbox as follows:
"A" Holding tie-rod end, repeat lock to lock two or
three times as quickly as possible.
"B" Holding tie-rod end, turn it slowly at a radius one
or two times as large as possible.
After all, make sure that the boot is installed in the
specified position without deflation.
36) Remove the gearbox from ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
37) Install the four pipes on gearbox.
(1) Connect the pipes A and B to the four pipe
joints of gearbox.
Tightening torque:
⋅
13 N m (1.3 kgf-m, 9.6 ft-lb)
Steering Gearbox [LHD Model]
L
PS-00097
A
B
PS-00098
(2) Connect the pipes C and D to gearbox.
Tightening torque:
Pipe C: 15 N
Pipe D: 25 N
(2)
(1) Pipe C
(2) Pipe D
2. CONTROL VALVE ASSEMBLY
Steering grease:
VALIANT GREASE M2 (Part No. 003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to
the inner wall of valve housing.
(1) Apply fluid.
3) To avoid scratching oil seal, apply a coat of
grease to the contact surface of installer and oil
seal.
4) Verify the direction of oil seal. Install the oil seal
to installer and position it to valve housing.
PS-38
⋅
m (1.5 kgf-m, 10.8 ft-lb)
⋅
m (2.5 kgf-m, 18.4 ft-lb)
(1)
(1)
PS-00525
PS-00169