Subaru Legacy 2005 Service Manual page 3303

4) Remove the piston boot.
5) Remove the piston seal from caliper body cylin-
der.
CAUTION:
Do not damage the cylinder and piston seal
groove.
(1) Piston seal
6) Remove the guide pin and boot from caliper
body.
2. 16-INCH TYPE
Refer to 15-inch type. <Ref. to BR-22, 15-INCH
TYPE, DISASSEMBLY, Front Disc Brake Assem-
bly.>
3. 17-INCH TYPE
Refer to 15-inch type. <Ref. to BR-22, 15-INCH
TYPE, DISASSEMBLY, Front Disc Brake Assem-
bly.>
Front Disc Brake Assembly
BR-00240
(1)
BR-00027
D: ASSEMBLY
1. 15-INCH TYPE
1) Clean the caliper body interior using brake fluid.
2) Apply a coat of brake fluid to the piston seal and
fit piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner sur-
face of cylinder and outer surface of piston.
4) Apply a coat of specified grease to the boot and
fit in to the groove on ends of cylinder.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into cylinder.
CAUTION:
Do not force the piston into cylinder.
(1) Piston
(2) Piston boot
6) Position the boot in the grooves on cylinder and
piston.
(1) Piston
(2) Piston boot
(3) Caliper body
(4) Piston seal
7) Apply a coat of specified grease to inner surface
of cylinder, lock pin, guide pin, periphery of bushing
and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
BR-23
BRAKE
(2)
(1)
BR-00242
(3)
(4)
(2)
(1)
BR-00243