Table of Contents
Advertisement
Direction of spindle
rotation
6 – 186
MP3412
Multiplication factor for MP3411.x
Input:
0.000 to 1.999
MP3412.0
with M05
MP3412.1
with spindle orientation
MP3412.2
for tapping with floating tap holder
MP3412.3
for tapping without floating tap holder
M4001
Nominal speed command signal of
the spindle not in the ramp
M4002
Nominal speed value = 0
7 7 7 7
With MP3130, define the polarity of the nominal speed value
7 7 7 7
In MP3140, enter the counting direction of the position encoder signals.
As soon as you set M4005 for M03, or M4006 for M04, the nominal speed
value is output. With M4007 for M05, the nominal speed value zero is output
(spindle stop).
M4005 to M4007 also controls the miscellaneous functions in the status
window. (See "Position and Status Display" on page 6 – 231).
If more than one marker is set at the same time, the error message
PLC: M4005, M4006, M4007 INCORRECT appears.
With M4014 you can reverse the direction of rotation, in order to adjust the
transmission for horizontal or vertical spindles, for example. The polarity of the
nominal spindle speed is inverted.
M4019 reverses the counting direction of the spindle.
MP3130
Polarity of the nominal spindle speed
Input:
0: M03 positive, M04 negative
1: M03 negative, M04 positive
2: M03 and M04 positive
4: M03 and M04 negative
MP3140
Counting direction of spindle position encoder output
signals
Input:
0: Positive counting direction with M03
1: Negative counting direction with M03
M4005
Status display and nominal speed
value output for M03
M4006
Status display and nominal speed
value output for M04
M4007
Status display M05 and spindle stop PLC
M4014
Reverse the direction of spindle
rotation
M4019
Reversing the counting direction of
the position encoder on the spindle
HEIDENHAIN Technical Manual TNC 426, TNC 430
Set
Reset
NC
NC
NC
NC
Set
Reset
PLC
PLC
PLC
PLC
PLC
PLC
PLC
PLC
PLC
Advertisement
Table of Contents
