Table of Contents
Advertisement
December 2001
In this case there will be several reference pulses per revolution.
7 7 7 7
Evaluate the reference mark with Module 9220 (See "Renewed traversing
of the reference marks " on page 6 – 103).
If MP3143 = 2, then the reference pulse release for the spindle position
encoder is set with X30, pin 1. Ensure that the same reference signal is always
evaluated.
If MP3143 = 1 or 3, then X30 pin 1 is evaluated as the reference signal. The
reference mark of the position encoder is not evaluated. In the case the
reference signal must be evaluated with Module 9220 ((See "Renewed
traversing of the reference marks " on page 6 – 103)).
Warning
Due to its low accuracy, this solution is not recommended.
MP111
Position encoder input for the spindles
Input:
0: No position encoder input
1 to 6: Position encoder inputs X1 to X6
35 to 38: Position encoder inputs X35 to X38
MP111.0
Position encoder input for the first spindle
MP111.1
Position encoder input for the second spindle
MP3142
Line count of the spindle position encoder
Input:
100 to 9 999 [lines]
MP3143
Mounting configuration of the spindle position encoder
Input:
0: Position encoder immediately on the first spindle
1: Position encoder via transmission (ratio in MP3450.x and
MP3451.x); X30 pin 1: reference pulse
2: Position encoder via transmission (ratio in MP3450 and
MP3451); X30 pin 1: reference pulse release
3: Same as input value 1, except that the second reference
pulse is evaluated.
MP3450.0-7 Number of spindle position-encoder revolutions for gear
ranges 1 to 8
Input:
0 to 65 535
0: No transmission
MP3451.0-7 Number of spindle position-encoder revolutions for gear
ranges 1 to 8
Input:
0 to 65 535
0: No transmission
Spindle
6 – 181
Advertisement
Table of Contents
