HEIDENHAIN TNC 426 PB/M Technical Manual page 875

Group Group
name number
ID....
Touch probe cycles
990
Coordinate transformation
PLC data
2000
7 – 26
System data System data
number index
NR.... IDX....
1 –
2 –
3 –
6 –
4 1
2
5 5
8 –
10 Marker no.
System data item
Approach behavior:
0 = Standard behavior
1 = Effective radius, safety clearance
zero
0 = Probe monitoring off
1 = Probe monitoring on
Place probe data of the manual
probing cycles into the tool table
Touch probe cycle 3
0.0 = Input X12
1.0 = Input X13
Transformation of the manual mode
coordinate system into the active
coordinate system (e.g. rotated,
shifted ).
Transformation of the active
coordinate system (e.g. rotated,
shifted ) into the manual mode
coordinate system.
Ask if due to a tilt motion, an axis is
shown in an untilted coordinate
system on top of another axis. The
number of the first of two sequential
Q parameters must be given. It
contains the axis to be asked (0 = X,
1 = Y, 2 = Z).
The second Q parameter should
return the corresponding image (0 =
X, 1 = Y, 2 = Z, –1 = Axis has no
image).
Spindle orientation including the
angle
PLC markers
HEIDENHAIN Technical Manual TNC 426, TNC 430