HEIDENHAIN TNC 426 PB/M Technical Manual page 574

Transferred number
23 Handwheel superimposition with
M118
Handwheel interpolation factor
31 Axis 1
32 Axis 2
33 Axis 3
34 Axis 4
35 Axis 5
36 Axis 6
37 Axis 7
38 Axis 8
39 Axis 9
1000 Table editor (only in a spawn job or
submit job)
1001 Pallet table (only in a spawn job or
submit job)
1002 Status of pallet processing
6 – 244
Return code
0 to 10
>= 0: Active line in the table editor
–1: Table editor not active
>= 0: Active line in the pallet table
–1: Pallet table not active
–1: Main program is not a pallet table.
0: Processing was not started.
1: NC program is selected but not started.
2: NC program was started.
3: Pallet-change macro was started.
4: Macro from the PALEPILOG entry in the
NCMAKRO.SYS was started.
5: Pallet-change macro was started by the PLC
(Module 9280).
Call:
PS B/W/D/K <Number of the desired status information>
CM 9035
PL B/W/D <Status information>
Error recognition:
Marker Value Meaning
M4203 0 No error
1 Error code in W1022
W1022 1 Status information invalid
20 Call was not in a submit or spawn job
HEIDENHAIN Technical Manual TNC 426, TNC 430