HEIDENHAIN TNC 426 PB/M Technical Manual page 636

6 – 306
M4160 Pallet table selected
MP7683 Executing pallet tables
Format: %xxxxx
Input: Bit 0 – PROGRAM RUN, SINGLE BLOCK operating mode:
0: During the start, a line of the NC program is run. The pallet
change macro is executed completely.
1: During the start, a complete NC program is run.
Bit 1 – PROGRAM RUN, FULL SEQUENCE operating mode:
0: During the start, a complete NC program is run.
1: At the start all NC programs are executed up to next pallet.
Bit 2 – PROGRAM RUN, FULL SEQUENCE operating mode:
0: As defined in bit 1
1: All NC programs and pallets up to the end of the table are
executed .
Bit 3 – When the end of the table is reached, the process begins
again with the first line.
0: Function is not in effect
1: Function is effective (bit 2 = 1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot be edited.
1: The active pallet can be edited in the PROGRAM RUN, FULL
SEQUENCE and PROGRAM RUN, SINGLE BLOCK modes.
Bit 6 – Display of pallet table and NC program
0: Both simultaneously in a split screen
1: Pallet table or NC program individually
Module 9090 Selection of a line in the pallet table
With this module, you set the cursor on a particular line of the pallet table that
you selected in the program run mode. If the TNC is in another mode, the
selection will be made when the control returns to the program run mode.
The selection is possible only as long as no pallet file has been started.
Call only in a submit job or spawn job.
Call:
PS B/W/D/K <Line number in the pallet table>
CM 9090
PL B/W/D <Error code>
0: No error. The line was selected.
1: Module was not called in a spawn job or submit job
2: Call during running program
3: No pallet table selected in full sequence
4: Line does not exist
HEIDENHAIN Technical Manual TNC 426, TNC 430
Set Reset
NC NC