HEIDENHAIN TNC 426 PB/M Technical Manual page 573

Transferred number
5 Selected file in "Programming and
editing" and "Test run" modes
6 Selected file in "Program run, full
sequence" and "Program run, single
block"
7 Selected axis for actual position
capture in PROGRAMMING AND
EDITING
8 Selected axis for actual position
capture in POSITIONING WITH
MANUAL DATA INPUT
9 Handwheel axis
10 Handwheel axis, bit encoded
Handwheel interpolation factor
11 X key
12 Y key
13 Z key
14 IV key
15 V key
16 Input format of the $MDI file
17 Display format
18 Working plane
19 Active line in the .CMA file
20 HR 410 speed
21 Control model
22 Status of M128
December 2001
Return code
0: No file
1: .H (conversational NC PGM)
2: .I (ISO NC PGM)
3: .T (tool table)
4: .D (datum table)
5: .P (pallet table)
6: .A (ASCII file)
7: .TCH (pocket table)
0: No file
1: .H (conversational NC PGM)
2: .I (ISO NC PGM)
0 to 8: Axes 1 to 9
0 to 8: Axes 1 to 9
–1: None or more than one
Axes 1 to 9
Axis 1 to 9
0 to 10
0: .H (conversational NC PGM)
1: .I file (ISO NC PGM)
0: MM
1: INCHES
Bit 0=1: Tilting is active
Bit 1=1: Tilting is selected for manual operation
Bit 2=1: Tilting is selected for program run
>=0: Line number
–1: No .CMA file
0: Slow
1: Medium
2: Fast
0: TNC 310
1: TNC 370
2: TNC 410
3: TNC 426 CA/PA
4: TNC 426 CB/PB/M or TNC 430 CA/PA/M
0: M128 not active
1: M128 active
Display and Operation 6 – 243