Table of Contents
Advertisement
6.13.4 Position and Status Display
Position display
step
Position display of
the tool axis
December 2001
The status display shows the status of the control.
With a soft key you can activate an additional status display in the graphic
window instead of the graphic.
This information includes:
n
Axis positions
n
Tools
n
Nominal feed rate
n
M Functions
To define the position display step for axis and spindle positions:
7 7 7 7
Enter the desired display step for the axes in MP7290.x and for the spindle
in MP7289.
The position loop resolution is not influenced by this parameter.
MP7290.0-8 Position display step for axes 1 to 9
Input:
0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.005 mm or 0.005°
6: 0.0001 mm or 0.0001°
MP7289
Position display step for the spindle
Input:
0: 0.1°
1: 0.05°
2: 0.01°
3: 0.005°
4: 0.001°
5: 0.0005°
6: 0.0001°
The tool length can be offset in the position display of the tool axis. If it is, the
displayed position value then refers to the tool point:
7 7 7 7
With MP7285, select whether the tool length should be offset.
The behavior of an incremental block after a TOOL CALL can be determined:
7 7 7 7
With MP7682 bit 0, select whether the tool length should be offset.
MP7285
Tool length offset in the tool-axis position display
Input:
0: Tool length is not offset
1: Tool length is offset
MP7682
Machine parameter with multiple function
Input:
%xxx
Bit 0 – Incremental block after TOOL CALL
0: with length compensation
1: without length compensation
Display and Operation
6 – 231
Advertisement
Table of Contents
