Table of Contents
Advertisement
4.3.11 Digitizing with Measuring Touch Probe (option)
MP
Function and input
MP6310
Deflection depth of the stylus (measuring touch probe)
Input:
MP6320
Counting direction of encoder output signals (measuring
touch probe)
Format:
Input:
MP6321
Measuring the center offset while calibrating the measuring
touch probe
Input:
MP6322.0-2
Assignment of the touch probe axes to the machine axes X,
Y and Z
Input:
MP6330
Maximum deflection of the stylus
(measuring touch probe)
Input:
MP6350
Feed rate for positioning to the MIN point and approaching
the contour (measuring touch probe)
Input:
MP6360
Probing feed rate (measuring touch probe)
Input:
MP6361
Rapid traverse in probing cycle (measuring touch probe)
Input:
MP6362
Feed rate reduction, if the stylus of the measuring touch
probe is deflected to the side
Input:
MP6370
Radial acceleration when digitizing with measuring touch
probe
Input:
MP6390
Target window for contour line
Input:
4 – 42
0.1000 to 2.0000 [mm]
%xxx
Bits 0 to 2 represent axes X to Z
0: Positive
1: Negative
0: Calibration with measurement of the
Center offset
1: Calibration without measuring the
Center offset
0: Touch probe axis X
1: Touch probe axis Y
2: Touch probe axis Z
0.1 to 4.000 [mm]
1 to 3000 [mm/min]
1 to 3000 [mm/min]
10 to 10 000 [mm/min]
0: Feed rate reduction not active
1: Feed rate reduction active
0.001 to 3.000 [m/s]
Recommended input value: 0.1
0.1000 to 4.0000 [mm]
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software
Page
version and
behavior
PLC, CN123 6 – 368
CN123
6 – 368
CN123
6 – 353,
6 – 369
CN123
6 – 369
CN123
6 – 369
CN123
6 – 369
CN123
6 – 349,
6 – 369
CN123
6 – 350,
6 – 369
PLC, CN123 6 – 369
PLC, CN123
6 – 369
RUN
PLC, CN123 6 – 369
Advertisement
Table of Contents
