Table of Contents
Advertisement
6 – 24
Module 9152 Selecting traverse range, axis display and axis designation
As of NC software: 280 476-01
With Module 9152 you can select the traverse range, the axis designation, and
the axis display. The axis designations in MP100.x and the axis display in
MP7291 are overwritten and cannot be activated until the module has
received –1 for the axis designation and axis display, a traverse range has been
activated with M4135, MP100.x or MP7291 have been edited, or the control
has been reset.
When the module is called it sets M4135. After switchover the NC resets
M4135.
Call:
PS
B/W/D/K/S<String with IV and V key configuration>
Format: AB
The first character represents the IV key, the second
character represents the V key
With –1 the key configuration from MP410 is valid
PS
B/W/D/K/S<String with axis display>
Format: SWVUCBAZYXwvucbazyx
Characters 1 to 9 (from the right) represent lines 1 to 9
Character 10 = S always in line 10
With –1 the axis display from MP7291 is valid
PS
B/W/D/K/S<String with axis designation>
Format: XYZABCUVWxyzabcuvw
Characters 1 to 9 correspond to axes 1 to 9
With –1 the axis designations from M100.x are valid
PS
B/W/D/K <Traverse range>
0 to 2: Range of traverse
–1: Do not change range of traverse
CM
9152
Error recognition:
Marker
Value
Meaning
M4203
0
Traverse range, axis designation and axis display are
switched
1
Error code in W1022
W1022
2
Invalid value for traverse range, or string for axis
configuration, axis display or key configuration is too
long
3
For the axis assignment, axis display or key
configuration, neither a string nor –1 was transferred
21
The module was called during a running program or
without an M/S/T/T2/Q strobe
HEIDENHAIN Technical Manual TNC 426, TNC 430
Advertisement
Table of Contents
