Table of Contents
Advertisement
NC Software
280 476-10 (export
version 280 477-10)
NC software
280 476-11 (export
version 280 477-11)
NC software
280 476-12 (export
version 280 477-12)
NC software
280 476-13 (export
version 280 477-13)
NC software
280 476-14 (export
version 280 477-14)
December 2001
Release: 06/00
n
MP6165: New probing function for the TS 632
n
New password AXISNUMBER for OEM.SYS, to limit the number of
machine parameter indexes
Release: 07/00
n
MP1087.x: Axis-specific jerk for Manual mode
n
MP7680 bit 12: Behavior of Cycle 28
n
New error message for FN14
n
FN17 ID990: Axis shown on top of other axis due to tilting motion?
Release: 07/00
Release: 10/00
n
MP110.x and MP111.x no longer result in a RESET
n
Maximum input ranges for MP2391.x, MP2393.x, MP2395.x, MP2500.x,
MP2501.x, MP2510.x and MP2511.x, MP6160, MP6161, MP6560, MP7442
expanded
n
MP7500 bit 8: Recalculate the datum to the home position of the tilting
element
n
EnDat multiturn encoders as position encoders
n
Actual-to-nominal value transfer only occurs in the affected axis during an
erasable positioning error
n
New function: Field orientation for synchronous spindles with encoders
without a Z1 track, or nonaligned encoders with EnDat interface
n
New motor table motor.mot
n
FN18 ID290: Determine the value of the bits in MP7500
n
Module 9146: Saving and reestablishing actual position values
n
Module 9147: Bit from W1032 is reset
n
Module 9157: Drive controller status
n
Behavior during calibration of the touch-trigger probe with infrared
transmission changed
n
Tool-by-tool execution of pallet tables
n
Cycle 431: Establish spatial angle
n
Cycle 247: Set a datum from a datum table as the datum in the REF system
Release: 11/00
n
FN18 ID214: Ascertain tolerance in Cycle 32 or MP1096
Software Releases
2 – 69
Advertisement
Table of Contents
