Table of Contents
Advertisement
NC software
280 474-15 (export
version 280 475-15)
NC software
280 474-16 (export
version 280 475-16)
December 2001
Release: 10/99
Improvements:
n
MP2221: Monitoring of rotational direction for spindle with integral DSP
n
Input range of the STR column in the motor tables expanded
n
When operating two spindles, the speed encoder may be disconnected and
reconnected
n
Direction monitoring of digitally controlled spindles
n
M4179: Control is shut down
n
M4220: Error from PET table/F stop active
n
M4221: Error from PET table/NC stop active
n
M4222: Error from PET table/EM. STOP active
n
Before the PLC program is converted, the PLC outputs are reset.
n
Module 9002, 9003, 9005, 9008, 9009: Error code 24 (Module was called in
the submit job or spawn job) added
n
Module 9130: New error codes 1 (Invalid analog output) and 2 (Disabled
analog output) added
n
Module 9189: The drive ready signal is removed
n
ISO: The Q key of the numerical keypad or the ASCII keyboard may be used
n
When the control is shut down, the hard disk is put into sleep mode.
n
Improved search function
n
Cycles 400 to 403: An error message appears if a measurement in a tilted
plane is to be carried out
n
Cycle 204: A value with digits after the decimal point may be entered in
Q255
Release: 03/00
Improvements:
n
MP420, MP430: Changes no longer lead to a control reset
n
MP2600: Input range changed
n
MP6510: Second measuring error added
n
MP7640, MP7641, MP7645 are no longer shown through code number 123
n
A German and an English machine parameter description, as well as the
configuration files for CycleDesign, are saved in PLC:\JH.
n
M141: Suppress touch probe monitoring
Software Releases
2 – 59
Advertisement
Table of Contents
