HEIDENHAIN TNC 426 PB/M Technical Manual page 292

MP Function and input
MP7310 Graphic display mode
Format:
Input:
MP7315 Tool radius for graphic simulation without TOOL CALL
Input:
MP7316 Penetration depth of the tool
Input:
MP7317 M function for graphic simulation
MP7317.0 Beginning of graphic simulation
Input:
MP7317.1 Interruption of the graphic simulation
Input:
MP7330.0-15 Specifying the user parameters 1 to 16
Input:
MP7340.0-15 Dialog messages for user parameters 1 to 16
Input:
4 – 54
%xxxx
Bit 0 – Projection in three planes:
0: German-preferred projection
1: US-preferred projection
Bit 1 – Rotation of the coordinate system in the
working plane by 90°:
0: No rotation
1: Rotation by +90°
Bit 2 – BLK form after datum shift:
0: Shifted
1: Not shifted
Bit 3 – Display of the cursor position:
0: No display
1: Display
0.0000 to 99 999.9999 [mm]
0.0000 to 99 999.9999 [mm]
0 to 88
0 to 88
0 to 9999.00 (no. of the user parameter)
0 to 4095 (line number of the PLC dialog
message file)
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software Page
version and
behavior
PLC, CN123 6 – 230
RUN
PLC, CN123 6 – 454
RUN
PLC, CN123 6 – 454
RUN
PLC, CN123 6 – 454
RUN
PLC 6 – 323
RUN
PLC 6 – 323
RUN