Table of Contents
Advertisement
NC software
280 476-15 (export
version 280 477-15)
NC software
280 476-16 (export
version 280 477-16)
NC software
280 476-17 (export
version 280 477-17)
NC software
280 476-18 (export
version 280 477-18)
2 – 70
Release: 11/00
n
MP7441 bit 1: Reserved
n
MP7441 bit 2: Error message when a positive depth is programmed in
machining cycles
n
MP7682 bit 3 and bit 4: Reserved
n
Was M4051 set before starting the probe block?
Release: 12/00
n
MP2221: Monitor ERR-IZ signal
n
MP7430: Input range changed
n
FN18 ID210 NR8: Angle of misalignment between the spindle and the tilted
coordinate system
n
FN18 ID360 NR3: Measurement results of touch probe cycles 0 and 1
without probe radius and length compensation
Release: 03/01
n
MP2397: Can be changed by the PLC
n
MP7683 bit 7: Execute AUTOSTART function by PLC
n
M4182: AUTOSTART function activated
n
M4183: Time for AUTOSTART function expired
n
STRICTREPOS= in OEM.SYS can be used to activate the function for restoring
the position when an NC program is interrupted during Single Block mode
or by a STOP block and the positions of the NC axes are changed.
n
Check the available memory on the hard disk when the control is started
n
Check the cycle data when the control is started and enter information into
the log file
n
Tool-oriented machining of pallet tables
Release: 04/01
n
MP1060.x and MP1070.x: Input range expanded
n
In volts-per-hertz control mode, W322 = 0
n
Improved behavior when using a speed encoder with EnDat interface
HEIDENHAIN Technical Manual TNC 426, TNC 430
Advertisement
Table of Contents
