Table of Contents
Advertisement
7 – 42
MPPASSWORD: Code number for calling the machine parameter file (instead
of 95148)
Example entry: MPPASSWORD = MP
Note
Do not enter a code number that has already been defined by
HEIDENHAIN!
MPLOCKFILE: Path of a machine parameter subfile. If there are differences
between this file and the current machine parameter file, an error message
appears and the value from this subfile is offered for acceptance.
Example input: MPLOCKFILE = PLC:\MP\280474.MPL
TTYP: Path and file name for list of the tool types
PLCERRFIX: Path for "corrective action" help text
PLCERRREASON: Path for "cause of error" help text
PLCEVENTS: Path event list (spawn command)
LSV2TIME0: Timeout for block reception (STX to ETX)
LSV2TIME1: Timeout for acknowledgment of ENQ or checksum
LSV2TIME2: Timeout during transmission of DLE 0, DLE 1 or NAK until
reception of a valid character
KINEMATIC: Path for the tilting-axis geometry description assignment table
Example input: KINEMATIC = PLC:\KINELIST.TAB
REMOTE.LOCKSOFTKEYVISIBLE: Display External access ON/OFF soft key.
REMOTE.PLCPASSWORDNEEDED: Access to the PLC partition using the
LSV2 protocol only with the password from PLCPASSWORD =
REMOTE.PLCPASSWORDFORCED: Machine backup, full backup and setup
only with the password from PLCPASSWORD =
AXISNUMBER: Number of axes for which machine parameter indexes should
be entered in the machine parameter file.
STRICTREPOS: The function for restoring the position is activated when an
NC program block is interrupted during Program Run, Single Block or by a
STOP and the positions of the NC axes are changed.
HEIDENHAIN Technical Manual TNC 426, TNC 430
Advertisement
Table of Contents
