HEIDENHAIN TNC 426 PB/M Technical Manual page 46

Table of Contents

On the PC, enter the command SETUP or SETUP32 to copy the NC dialogs,

HEIDENHAIN cycles etc. from the provided setup disks. After setup the

control carries out a RESET.

• DOS and Windows in the DOS window: Use the SETUP command,

followed by the number of the PC's serial port (e.g., SETUP 2 for the

• Windows 95, 98, NT: Use the SETUP32 command, followed by the

number of the PC's serial port (e.g., SETUP32 2 for the COM2 port) or the

TNC's IP address (e.g., SETUP32 160.1.180.21).

As of NC software 280 476-17, when the control starts, it checks whether

there is enough space on the hard disk for system files. If not, the error

message Too many setup files appears. In this event, delete any

unnecessary setup files from the hard disk. (See "Activating and deleting

already existing NC software" on page 2 – 39.)

On the TNC, switch to the PROGRAMMING AND EDITING mode of

operation and press the MOD key.

Enter the code number 95148 and confirm with ENT.

In the machine-parameter-editing mode of operation, press the MOD key.

Convert updated data to binary format: Press the soft key UPDATE DATA

and CONVERT ASC -> BIN. The name of a log file may also be entered.

Read-in files which you had saved to a PC.

End of the NC software switch.

With the COPY SAMPLE FILES soft key, the cutting data tables, the tables

for tilted-axis geometry, and the table of M-function macros can be copied

into the corresponding directory.

HEIDENHAIN Technical Manual TNC 426, TNC 430