HEIDENHAIN TNC 426 PB/M Technical Manual page 881

Group Group
name number
ID....
Measuring touch probe
350
Datum from touch probe cycle
360
Read values from active datum table
500
501
505
7 – 32
System data System data
number index
NR.... IDX....
30 –
31 –
32 –
33 –
34 1
2
35 1
2
3
36 1
2
3
1 1 to 9
2 1 to 9
3 –
Line Column
Line Column
1 –
System data item
Effective length
Effective radius 1
Effective radius 2
Diameter of calibration ring
Center offset (reference axis)
Center offset (minor axis)
Compensation factor in axis 1
Compensation factor in axis 2
Compensation factor in axis 3
Power ratio in axis 1
Power ratio in axis 2
Power ratio in axis 3
Last datum of a manual touch probe
cycle or last touch point from cycle 0
for the axes 1 to 9 without probe
length compensation, but with probe
radius compensation (workpiece
coordinate system)
Last datum of a manual touch probe
cycle or last touch point from cycle 0
for the axes 1 to 9 without probe
length or radius compensation
(machine coordinate system)
Measurement result of touch probe
cycles 0 and 1 without probe radius
and length compensation
Read values
Read REF values
0 = no datum table selected
1 = datum table selected
HEIDENHAIN Technical Manual TNC 426, TNC 430