And Not (An) - HEIDENHAIN TNC 426 PB/M Technical Manual

7.7.20 AND NOT (AN)

Logic processing
with the AND NOT
command
Function
Load the operand
content into the logic
accumulator.
Gate the content of
logic accumulator
and input I5 with
AND NOT.
Assign the gating
result to output O2.
7 – 104
Syntax: AN (AND NOT)
Operands: M, I, O, T, C
Action:
n
At the beginning of a logic sequence, this command functions like an LN
command, i.e., the logical state of the operand is loaded into the logic
accumulator. However, you should always begin a sequence of logical
gating operations with a load command (see L, LN, L–).
n
Within a logic sequence, gate the content of the logic accumulator and the
logical state of the operand with AND NOT. The TNC saves the result of the
operation in the logic accumulator.
Example:
Gate the inputs I4 and I5 with AND NOT, and assign the result to output O2.
Initial state:
Input I4 = 1
Input I5 = 1
Output O2 = ?
STL Accumulator contents [bit]
31..15 ..................... 7 ................. 0
L I4 x ..... x x x x x x x x 1 x x x x x x x
AN I5 x ..... x x x x x x x x 0 x x x x x x x
= O2 x ..... x x x x x x x x 0 x x x x x x x
HEIDENHAIN Technical Manual TNC 426, TNC 430
Operand contents [bit]
1
1
0