Software Type - HEIDENHAIN TNC 426 PB/M Technical Manual

Software type

Hardware LE 426 C/P, LE 430 C/P
version
xxx xxx-1x –
xxx xxx-2x 280 470-xx
280 472-xx
xxx xxx-3x 280 470-xx
280 472-xx
xxx xxx-4x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
xxx xxx-5x 280 470-xx
280 472-xx
280 474-xx
280 476-xx
December 2001
The following software versions are available for the TNC 426 and TNC 430
controls:
NC software version
4 EPROMs
280 470-xx
4 EPROMs
280 472-xx
4 EPROMs
280 474-xx
6 EPROMs
280 476-xx
(Delivered software)
NC software version
280 476-xx
Due to restrictions on the export of the TNC, HEIDENHAIN can also supply a
special export version. This export version differs from the standard control
though the installed NC software version. HEIDENHAIN releases a new NC
software version whenever it introduces extensive new functions.
Certain software versions do not run on all hardware versions. Please consult
the following table, which assigns each NC software version to a hardware
version:
LE 426 M, LE 430 M
324 990-xx to 324 997-xx
(EPROMs)
–
280 474-xx
280 476-xx
280 474-xx
280 476-xx
–
–
Software
Setup disks
1 disk
280 640-xx
3 disks
280 641-xx
(to 280 641-05 2 disks)
3 disks
286 195-xx
4 disks
286 197-xx
(to 286 197-03 3 disks)
Data record for controls with flash EPROMs
Standard
340 436-xx
LE 426 M, LE 430 M
344 958-xx to 344 965-xx
(flash EPROMs)
as of 280 476-07
–
–
–
–
Export version
4 EPROMs
280 471-xx
4 EPROMs
280 473-xx
4 EPROMs
280 475-xx
6 EPROMs
280 477-xx
Export
340 437-xx
2 – 31