HEIDENHAIN TNC 426 PB/M Technical Manual page 290

MP Function and input
MP7267 Elements of the pocket table
Input:
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7270 Feed-rate display in the MANUAL OPERATION and
ELECTRICAL HANDWHEEL operating modes
Input:
MP7280 Decimal character
Input:
MP7281 Depiction of the NC program
Input:
MP7285 Tool length offset in the tool-axis position display
Input:
MP7289 Position display step for the spindle
Input:
4 – 52
0: No display
1 to 99: Position in the pocket table
0: Display of feed rate by pressing
an axis direction key (axis-specific
feed rate from MP1020)
1: Display of the feed rate also before
pressing an axis direction key
(smallest value from MP1020 for all axes)
0: Decimal comma
1: Decimal point
0: All blocks completely
1: Current block all at once, others line by line
2: All blocks line by line; block when editing
all at once
0: Tool length is not offset
1: Tool length is offset
0: 0.1°
1: 0,05°
2: 0,01°
3: 0,005°
4: 0,001°
5: 0,0005°
6: 0,0001°
HEIDENHAIN Technical Manual TNC 426, TNC 430
Software Page
version and
behavior
CN123 6 – 404
PLC, CN123 6 – 237
RUN
PLC, CN123 6 – 326
RUN
280 476-03 6 – 245
PLC
RUN
PLC, CN123 6 – 231
RUN
280 474-09 6 – 231
PLC, CN123
RUN