Table of Contents
Advertisement
NC software
280 470-xx
December 2001
In the pallet tables you can assign NC programs and datum tables to specific
workpieces.
You can define up to 255 assignments per table:
7 7 7 7
In MP7226.0, define the size of the table.
7 7 7 7
With Module 9090, select the assignment by entering the line number. With
the next NC START the selected NC program is run with the associated
datum table.
The desired pallet must have the status "M":
7 7 7 7
With PGM MGT, select the pallet table in the PROGRAM RUN, FULL
SEQUENCE operating mode.
If no datum table is specified in the pallet table, the previous file is kept.
Files that you have disabled in MP7224.0 are ignored in the pallet table. If
locked HEIDENHAIN programs or ISO programs are selected, the error
message NC PROGRAM NOT FOUND appears.
MP7226.0
Size of the pallet table
Input:
0 to 255 [lines]
Module 9090 Assignment of a pallet table
Call only in a submit job or spawn job.
Call:
PS
B/W/D/K <Line number in pallet table>
CM
9090
PL
B/W/D
<Error condition>
As of 280 470-01:
0: Files were selected
1: Call was not in a submit or spawn job
2: Call during running program
3: Pocket calculator not in default state
4: Pallet table not found
5: Line in pallet table does not exist
6: Incorrect type entered for NC program or point missing
7: NC program not found
8: NC program ambiguous
9: Datum table not found
11: Pallet entry missing in NCPATH.SYS
12: Incorrect file name extension
As of 280 472-01:
0: Files were selected
1: Call was not in a submit or spawn job
2: Call during running program
3: No pallet table selected in main program
4: Line in pallet table does not exist
Display and Operation
6 – 309
Advertisement
Table of Contents
