HEIDENHAIN TNC 426 PB/M Technical Manual page 348

6 – 18
MP111 Position encoder input for the spindle(s)
As of software version:280 474-03
Input: 0: No position encoder input
1 to 6: Position encoder inputs X1 to X6
35 to 38: Position encoder inputs X35 to X38
MP111.0 Position encoder input for the first spindle
MP111.1 Position encoder input for the second spindle
MP113 Speed encoder for the spindle(s)
As of software version:280 474-03
MP113.0 Speed encoder for the first spindle
Input: 0: No speed encoder input
15 to 20: Speed encoder inputs X15 to X20
60: Speed encoder input X60 (only on LE with integral spindle
DSP)
62 to 64: Speed encoder inputs X62 to X64
MP113.1 Speed encoder for the second spindle
Input: 0: No speed encoder input
15 to 20: Speed encoder inputs X15 to X20
62 to 64: Speed encoder inputs X62 to X64
MP121 Nominal speed command output of the spindle(s)
As of software version:280 474-01
MP121.0 Nominal speed command output of the first spindle
Input: 0: No servo-controlled spindle
1 to 6: Analog outputs 1 to 6 at terminal X8
7 to 13: Analog outputs 7 to 13 at terminal X9
51 to 59, 61: Digital output X51 to X59, X61
MP121.1 Nominal speed command output of the second spindle
Input: 0: No servo-controlled spindle
1 to 6: Analog outputs 1 to 6 at terminal X8
7 to 13: Analog outputs 7 to 13 at terminal X9
51 to 59: Digital outputs X51 to X59
Note
Remember the arrangement of power modules when assigning the speed
command signal outputs of the LE 426 M, LE 430 M.
MP121 Nominal speed command output of the spindle
As of software version:280 470-01
Input: 0: No servo-controlled spindle
A1 to A6 or 1 to 6: Analog outputs 1 to 6 at terminal X8
A7 to A13 or 7 to 13: Analog outputs 7 to 13 at
terminal X9
S1: Digital spindle
Note
Only the values from 0 to A13 are permissible. Enter the digital spindle in
MP2001.
HEIDENHAIN Technical Manual TNC 426, TNC 430