Software Option; Plc Software - HEIDENHAIN TNC 426 PB/M Technical Manual

2.5.2 Software Option

2.5.3 PLC Software

2 – 32
The following software options are available for the TNC 426 and TNC 430:
n
Digitizing with triggering touch probe
n
Digitizing with triggering and measuring touch probes
If you have ordered a TNC with an option, the software number will be
supplemented by an option number displayed after the TNC is switched on.
The TNC can also be retrofitted with one of the options. Please contact
HEIDENHAIN for further information.
Option
Digitizing with triggering
touch probe
Digitizing with the SP 2/1
triggering and measuring
touch probe
The PLC software is stored on the hard disk of the TNC. You can order a PLC
commissioning program directly from HEIDENHAIN. With the PLC
development software PLCdesign, the PLC program can very easily be
adapted to the requirements of the machine.
Option Id. Nr. of the
number adapter kit
1 286 405-01
11 TNC 426 CB/PB,
TNC 430 CA/PA:
311 647-51
TNC 426 M,
TNC 430 M:
325 818-51
HEIDENHAIN Technical Manual TNC 426, TNC 430
Id. Nr. of the
software module
246 051-01
–