Table of Contents
Advertisement
6.15.1 Touch Probe Cycles
Probing from the
NC program
Max. measuring
range (MP6130)
Probing in the
MANUAL and
ELECTRONIC HAND-
WHEEL operating
Max. measuring
range (MP6130)
December 2001
The probing cycles are available in the MANUAL and ELECTRONIC
HANDWHEEL modes and in the NC program (see User's Manual, Touch
Probe Cycles).
7 7 7 7
With the machine parameters, adjust the touch probe to the measuring
conditions.
7 7 7 7
With MP6165, you can specify if during manual measurement and in the
touch probe cycles 0 and 1 the touch probe with infrared transmission is
oriented so that it is always deflected in the same direction.
F1 = rapid traverse during probing from the NC program:
MP6150 for triggering touch probe
MP6361 for measuring touch probe
F2 = probing feed rate:
MP6120 for triggering touch probe
MP6360 for measuring touch probe
If the maximum measuring range (MP6130) is exceeded, the error message
TOUCH POINT INACCESSIBLE appears.
In the MANUAL and ELECTRONIC HANDWHEEL modes, MP6140, MP6150,
MP6361 have no meaning.
Touch Probe
Setup clearance
(MP6140)
6 – 347
Advertisement
Table of Contents
