HEIDENHAIN TNC 426 PB/M Technical Manual page 353

Table of Contents

December 2001

Select the traverse range (with

Select the traverse range (with

Strobe marker for selecting the

traverse range

Module 9151 Selecting traverse range and axis designation

As of NC software: 280 472-01

With Module 9151 you can select the traverse range and the axis designation

in one step. The axis designations in MP100.x are overwritten and cannot be

activated until the module has received the axis designation –1, a traverse

range has been activated with M4135, MP100.x is edited, or the control has

When the module is called it sets M4135. After switchover the NC resets

B/W/D/K/S<String with axis designation>

Format: XYZABCUVWxyzabcuvw

Characters 1 to 9 correspond to axes 1 to 9

With –1 the axis designations from M100.x are valid

B/W/D/K <Traverse range>

0 to 2: Range of traverse

–1: Do not change range of traverse

Error recognition:

Traverse range/axis designation switched over

Error code in W1022

Invalid value for traverse range

For the axis assignment, neither a string nor –1 was

The module was called during a running program or

without an M/S/T/Q strobe

Machine Axes