Table of Contents
Advertisement
3.12 Input: Spindle Reference Signal
X30: Reference
signal for spindle
December 2001
If you have mounted a HEIDENHAIN rotary encoder directly on the spindle,
i.e., without a mechanical transmission ratio, you must not connect this input.
If you use the X30 input for evaluation of the reference signal, then adjust this
function with MP3143. (See "Machine Parameters" on page 4 – 3).
Pin layout:
Connecting terminal
1
2
Input: Spindle Reference Signal
Assignment
+24 V
0 V
3 – 71
Advertisement
Table of Contents
